Análisis Térmico Dinamomecánico

DMA EPLEXOR® up to 500 N

High-Force DMA 

The testing instruments of the DMA GABO EPLEXOR® series up to ±500 N enable the dynamic mechanical (or static) characterization of a wide range of different materials including elastomers and polymers, composites, metals, glasses, ceramics, biomaterials and foods, adhesives, and liquids.

The modular design of the high-force DMA systems allows for measurements in the tension, compression, bending and shearing modes. The testing machines in this series differ from each other mainly in terms of their maximum dynamic force ranges of ±25 N, ±100 N, ±150 N and ±500 N.

Various add-on options make these testing machines a safe investment for the long-term.

All testing machines in this series are conform to standards such as DIN 53513, ISO 6721/1, ISO 6721/4, ISO 6721/5, ISO 6721/6, ISO 4664, ASTM D4065, and ASTM D4473.  

Flexible and Set for the Future
...by means of a variety of force and StrainStrain describes a deformation of a material, which is loaded mechanically by an external force or stress. Rubber compounds show creep properties, if a static load is applied.strain sensors as well as furnaces which allow for easy upgrades to the basic system at any time after the first installation

High Force Levels
...allowing for static loads up to 1500 N and dynamic loads up to ± 500 N; especially meaningful for investigations on curable resins, elastomers, composites, metals, glasses or ceramics

Two Independent Drives
...featuring a servo motor for static and a shaker for dynamic loads

Interchangeable Force Sensors
...which can be easily changed out by the operator; nominal loads available ranging from ±10 N to ±2500 N

24/7 Operation via the Automatic Sample Changer
...for tension, compression and bending samples across the entire temperature range around the clock

Optimized for Temperature Sweeps on Large Samples
...thanks to uniform heating of even large samples with low Conductividad TérmicaThermal conductivity (λ with the unit W/(m•K)) describes the transport of energy – in the form of heat – through a body of mass as the result of a temperature gradient (see fig. 1). According to the second law of thermodynamics, heat always flows in the direction of the lower temperature.thermal conductivity (e.g., large rubber specimens)

Highly Economic LN2 Cooling
...for low liquid nitrogen consumption

Simultaneous Determination of Dynamic Mechanical and Dielectric Material Properties     

Request a Quote

Get a personalized offer now.

Request a Quote

Datos Técnicos

Temperature range
-160°C to 1500°C (temperature range covered by three furnaces)
Static force range
up to 1500 N
Frequency range
0.01 Hz to 100 Hz; optional 0.0001 Hz and 200 Hz

Automatic sample length detection or thickness determination possible in tensile, compression and bending geometries  

Bibliografía técnica 

    Product Information

    We do not only promise quality, but also individual consulting. Let us start your project together.

    Request Information

    Vídeo

    Please accept Marketing Cookies to see that Video.

    NETZSCH GABO EPLEXOR® 500 N

    Please accept Marketing Cookies to see that Video.

    How to test Rubber - Predictive Testing in Tensile Mode - Part 2  

    Please accept Marketing Cookies to see that Video.

    Predictive Testing in the Tire Industry 

    Please accept Marketing Cookies to see that Video.

    How to use Segment Program with EPLEXOR® 9 Software 

    Please accept Marketing Cookies to see that Video.

    How to test Rubber - Predictive Testing in Tensile Mode - Part 1